UWELL Introduces the Blocks 90W Box combined with the Nunchaku 24mm bottom feed RDA. Unique is what you would call this device, the upper section of the Block Box Mod acts as a detachable unit from the bottom housing. Pulling the mods upper cap allows the users to access the battery housing and the squonk bottle. Squonking the Block is located at the top, a single press of a button will allow you to pump out every bit of flavor.
The UWELL Block has a proprietary chipset allowing it to have a maximum output of 90W. Power output of the device is based on the current state of the battery and is advised to use a battery with a minimum amperage of 30. Sliding the top portion of the Block will enable users to access the battery and squonk bottle. Powering the Blocks is a single high amperage 18650 (sold separately) and is housed on the upper portion of the mod. Next to the battery is the 15ml proprietary squonk bottle. Located on the top of the device is a button for users to squonk juice onto their preferred atomizer. A single control face makes this device simple; the oversized firing button is also equipped with an LED indicator that shows alerts (from vape protections) or battery life. When firing the LED light will correspond to how much battery life there is; Green being high, blue being medium, red being low.
Along with the UWELL Block Squonk Box Mod is the Nunchaku bottom fed rebuildable dripping atomizer. The Nunchaku has a diameter of 24mm and features a dual post clamp style build deck. Each terminal can be accessed with a Hex Key and features 2.5mm by 3mm slots for either single or dual coil configuration. Airflow enters the Nunchaku through dual 8mm by 2.5mm airflow slots and can be adjusted fully with two airflows open or with one. Located on the top of the Nunchaku is an 8mm wide bore drip tip that can be substituted with any 510 with the included adapter. On the bottom, users may choose to use the Nunchaku as a regular non-bottom fed RDA or with a squonk pin which comes pre-installed.
- Stainless steel construction
- POM drip tip
- Wide spacing build posts for single or dual coils building
- The non-stick coating on the RDA provides better oil and fingerprint resistant
- Adjustable airflow by twisting the airflow ring
- 510 threading connection
- 24mm overall diameter
Blocks mod features:
- 90W maximum output
- Recommended resistance range: 0.1-0.5ohm
- Patented juice pump, precisely 0.13ml for each pump
- 0.008s fast firing gives you instant satisfaction
- 15ml large capacity
- Plug-pull design makes the refill easy
- Leak-proof 510 connector prevents juice leaking into the mod
- Powered by single 18650 battery (battery sold separately)
- Protruding design on both sides for a unique feel for the mod
- Spring-loaded firing button
- Micro-USB charging port